Pinnacle-speakers GBU070 Manuel d'utilisateur télécharger pdf (Page 11)

ELECTRICAL REQUIREMENTS

1. Make sure that the power source conforms to the requirements of the furnace.

Disconnect the power source before performing any maintenance or electrical work.

2. Connect the electrical power according to the appropriate wiring diagram on the

following page.

3. Plug the power supply into a surge protected and grounded 15-amp branch circuit.

The outlet must have the correct polarity. With a voltage tester, check the outlet

and make sure you have a minimum 115 volts and that the branch circuit is not over

loaded with too many appliances. A surge protector must be used to have electrical

items warranted

THERMOSTAT INSTALLATION

THERMOSTAT IS SUPPLIED WITH UNIT

1. Install the thermostat in a central location. A low voltage 2-wire thermostat should

be used and installed according to manufacturers directions supplied with the

thermostat.

2. Run the thermostat wire (18/2 wire).

3. For best operation, mount the thermostat on a draft-free inside wall, if it must be

installed on an exterior wall; insulate the backside of the mounting plate.

4. See wiring diagrams for thermostat terminal locations. Leads for thermostat wire

connection off the primary control are yellow.

5. A programmable thermostat may be used but must be a 2-wire, low voltage type as

only 9 volts is switched, by the yellow wires on the primary control.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 28 29

Pas de commentaire

Pinnacle-speakers GBU070 Manuel d'utilisateur Page 11